- Top layer = clear transfer paper (through which you can see the picture)
- Middle layer = the the vinyl decal
- Bottom layer = white backing paper
- Clean your surface.
- Vinyl decals can be applied to walls, wood, glass, concrete, metal or any smooth, dry surface.
- Vinyl decals are easily removable, but NOT re usable
- Arrange your Vinyl Decal on your surface, DO NOT remove the white backing until you are happy with your layout.
- Flip the decal up. Starting from any corner, slowly peel the white backing away from the transfer tape, the vinyl decal should be sticking to the clear transfer tape. If some of the decal remains stuck to the white backing, stop. Rub the decal in that area and slowly continue peeling until the white backing is completely removed. Be Careful – once the vinyl decal is off the backing, it is extremely sticky, so hold it firmly at the edges so it won't fold in on itself. Position each portion of the vinyl decal on the surface starting at a corner and slowly smooth the image down flat, until the whole design is stuck firmly on the surface.
- With your finger or credit card finish the application by rubbing over the entire graphic to remove any air bubbles.
- Once you have removed the air bubbles carefully remove the transfer tape making sure that the decal is sticking to your surface and not the transfer tape. **If air bubbles cannot be pushed out, use a safety pin to poke a hole in the bubble and go over the area again.
No comments:
Post a Comment